Fabrication and characterization of polysulfone reinforced hollow fibre membrane.

In this study, reinforced hollow fibre membranes were fabricated using different molecular weights of polyvinylidene prolidone (PVP Mw: 10, 40 and 360 kDa) and different take-up speeds (1, 2, 2.6 and 3.5 m/min). Prepared reinforced hollow fibre membranes were characterized in terms of permeability; surface morphology and hydrophilicity; pore size distribution; bovine serum albumin (BSA) rejection and flux recovery ratio. Optimum permeability and BSA rejection were obtained when PVP molecular weight was 40 kDa. After PVP molecular weight determination, advancing speed was changed and it was seen that increasing advancing speed ended up with decreased membrane wall thickness; however, decreased wall thickness increased the probability of irreversible fouling.

Determination of the effect of proteoliposome concentration on Aquaporin Z incorporated nanofiltration membranes.

We report on the fabrication of AqpZ immobilized flat sheet membranes. The effects of interfacial polymerization conditions as well as proteoliposome concentration were evaluated. Commercial AqpZ were used as positive control for cloned AqpZ. Specific permeate flux of membranes at higher proteoliposome concentrations increased up to 25 times higher than thin film composite membranes; however; MgSO4 rejection is lowered almost to 1.5%. FTIR and SEM confirm immobilization of proteoliposomes. Thermal analysis showed that increasing proteoliposome concentration has no positive effect on the incorporation of proteoliposomes into polyamide structures. On the contrary, at lower proteoliposome concentrations, incorporation of proteoliposomes was found better. When combined membrane performances were compared in terms of specific permeate flux; MgSO4 and humic rejection and flux recovery after humic acid filtration, the performance of cloned AqpZ incorporated membranes (having 0.1 mg/mL proteoliposome concentration and polyamide formed with 2 min piperazine reaction time) improved 1.7 times regarding TFC membranes. According to the results, increasing proteoliposome concentration did not improve nanofiltration membrane performance. On the contrary, lower proteoliposome concentrations were found to be more effective in increasing membrane performance.

Occurrence of THM and NDMA precursors in a watershed: Effect of seasons and anthropogenic pollution.

In pristine watersheds, natural organic matter is the main source of disinfection by-product (DBP) precursors. However, the presence of point or non-point pollution sources in watersheds may lead to increased levels of DBP precursors which in turn form DBPs in the drinking water treatment plant upon chlorination or chloramination. In this study, water samples were collected from a lake used to obtain drinking water for Istanbul as well as its tributaries to investigate the presence of the precursors of two disinfection by-products, trihalomethanes (THM) and N-nitrosodimethylamine (NDMA). In addition, the effect of seasons and the possible relationships between these precursors and water quality parameters were evaluated. The concentrations of THM and NDMA precursors measured as total THM formation potential (TTHMFP) and NDMA formation potential (NDMAFP) ranged between 126 and 1523µg/L THM and <2 and 1648ng/L NDMA, respectively. Such wide ranges imply that some of the tributaries are affected by anthropogenic pollution sources, which is also supported by high DOC, Cl(-) and NH(3) concentrations. No significant correlation was found between the water quality parameters and DBP formation potential, except for a weak correlation between NDMAFP and DOC concentrations. The effect of the sampling location was more pronounced than the seasonal variation due to anthropogenic pollution in some tributaries and no significant correlation was obtained between the seasons and water quality parameters.

Ozonation of nonbiodegradable organics in tannery wastewater.

The study explores the impact of ozonation on the fate of different soluble COD fractions in the tannery wastewater at different phases during the course of biological treatment, in order to identify the phase where ozonation is likely to generate the maximum beneficial effect on biological treatability. Samples from the biological treatment influent and from the mixed liquor at periods significant for the fate of COD fractions have been ozonated. Ozone treatment at the phase where the readily biodegradable COD component was biologically depleted is determined as the most promising alternative among others, since the highest COD removal efficiencies are achieved even with low feeding time of 5 min at the selected ozone flow-rate of 42.8 mg min. The merit of ozonation at this stage in the formation of simpler more biodegradable compounds deserves further attention.